| BklynMDX |
For the guys/gals that have installed the steps, do you honestly need to use a torque wrench for the install? Or should I use it to not over-tighten the bolts in the chance that I might damage something?
Also, should there be plugs for the 2 dime sized holes under each step and what are they there for?
Thanks inadvance for your help. |
|
|
| msu79gt82 |
... I merely tightened the bolts until they were good and firm; not as hard as I could have.
Not sure about the holes, perhaps for drainage. |
|
|
| MDXdogmom |
quote:
Originally posted by BklynMDX
For the guys/gals that have installed the steps, do you honestly need to use a torque wrench for the install? Or should I use it to not over-tighten the bolts in the chance that I might damage something?
Also, should there be plugs for the 2 dime sized holes under each step and what are they there for?
I used a torque wrench and locktite on each bolt, both to keep them from working loose and primarily as a rust preventative. Not sure you really NEED to use the torque wrench, but get one - you'll use it for lots of other stuff like properly tightening the lug bolts. But whatever you do, don't get the beam type torque wrench with the needle display, get the click type torque wrench that click and break free when the correct torque is reached.
No plugs - those holes appear to be for drainage, eliminate condensation, etc.
Have fun - those 72 bolts were no fun in 30 degree weather!!
Barb |
|
|
| BklynMDX |
quote:
Originally posted by MDXdogmom
I used a torque wrench and locktite on each bolt, both to keep them from working loose and primarily as a rust preventative. Not sure you really NEED to use the torque wrench, but get one - you'll use it for lots of other stuff like properly tightening the lug bolts. But whatever you do, don't get the beam type torque wrench with the needle display, get the click type torque wrench that click and break free when the correct torque is reached.
No plugs - those holes appear to be for drainage, eliminate condensation, etc.
Have fun - those 72 bolts were no fun in 30 degree weather!!
Barb
Thank you for your input. Loctite sounds like a good idea. But how would I remove the nut in the future after I secure it with the Loctite? |
|
|
| EXCALIBUR |
BklynMDX,
Try using Loctite Blue. This formula can be loosened later on when you need to unbind something.:4: |
|
|
| BklynMDX |
quote:
Originally posted by EXCALIBUR
BklynMDX,
Try using Loctite Blue. This formula can be loosened later on when you need to unbind something.:4:
Do I need a blowtorch to loosen Loctite green/red? :p |
|
|
| EXCALIBUR |
BklynMDX,
Two 5,000 lb. bunker buster bombs should do it.;) |
|
|
| Markedoc |
| Just tighten them up snug ... When it's warmer and I get bored, I might crawl under and check them again to see if any have loosened. |
|
|
|
