| stumpie |
| Have noticed a couple of entries in this topic about adjusing of the headlights after the installation of HIDs. Was wondering about those of you that have recently installed your sets - have you adjusted 'a couple of turns' to bring the driver side in a little? Or have most/all of you left them as is and have not been getting flashed? Expect to receive my kit from the last group buy this week and am curious............ |
|
|
| xcel |
Hi Stumpie:
___I only marked off the cutoff on the top and didn’t even consider anything to the sides. In any case, the XenonDepot HID’s and the OEM Halogens cutoff on the top were almost exactly equal according to my duct tape on the garage installation technique.
___Good Luck
___Wayne R. Gerdes
___Hunt Club Farms Landscaping Ltd.
___Waynegerdes@earthlink.net |
|
|
| kseto007 |
| Ya same here, top cut off looks the same to me so I left the lights alone. I could show you before and after pics but it keep telling me the file is too large. I took the pic at the lowest setting on my camera so I dont know what to do, sorry. |
|
|
| jswift2000 |
| I had to bring my down 1 - 1.5 turns. |
|
|
| kseto007 |
jswift2000
Can you tell me how to lower the aim, I may want to just in case people start flashing me.
:confused: |
|
|
|
