ACURA MDX . ORG
www.acuramdx.org ACURA MDX . ORG Archive > General > Audio & Electronics
 
re-wire fog lights to turn signal - Click HERE for Original Thread
Advertisement
dean0224
Just an idea.
My other car has a small light turn on for near by corner area while turn on the signal light. I like that feature because the head light forcus on further straight ahead area only. but when I make a turn, I'd like to see clearly the near by ground or street coner where head light doesn't usually spot on it especially the X Projector-beam halogen headlights.

So,
Since the fog light is there and berely used. I found it light up the close up ground and corner area very well. It's should be very good if it can turn on/off with the signal light. NOT BLINKING, just keep on. And off when turning-signal off. either right or left or both is ok. I prefer both up with trun signal.

Just an idea. Didn't do that yet. check if anyone have done taht already or have better knowledge about how to do that.

:confused:

My guess is parallel wiring a switch (an relay switch) on the Fog light switch to the turn on/off signal.

Does anyone know how to do that ?
Warzau
Kinda like a Cadillac? That would make sense to use the light.
04mdx4sq
You would need to find the wire responsible for triggering the turn signal flasher and jump a wire to the relay responsible for the fog lights turning on. This wire would need to be diode isolated to avoid turning on the turn signals if the fog lights were turned on through the dash switch. This would allow you use of the fog lights in this manor. If you wanted to use the right side with right blinker, etc. there would be some major rewiring in order.

Powered by: Search Engine Indexer and vBulletin v2.2.9
Copyright © 2000 - 2002, Jelsoft Enterprises Limited
Copyright 2000 Acuramdx.org. All Rights Reserved.